Boiler Repair in Edison, NJ

Using this site is free and we never charge you anything. What a contractor charges to attend or diagnose is theirs to set — some credit a diagnostic fee against the repair, some do not — so agree that on the phone before they come out. It is a fair question and any reputable firm will answer it.

Once a year for each function — cooling in spring, heating in fall — so a house with separate heating and cooling equipment ideally gets two visits. Heat pumps run year-round and are generally serviced twice. Most manufacturer warranties also require documented annual servicing, and that condition is enforced more often than people expect.

Yes, and in most older housing that is the sensible route. A ductless mini-split needs a three-inch hole through the wall rather than duct runs, and it heats as well as cools. Running new ducts through a finished house means opening ceilings and building soffits, and it frequently costs more than the equipment does. Get both quoted before assuming ducts are the answer.

That comes from a load calculation on your actual house — floor area, insulation, window area and orientation, ceiling height, air leakage. It does not come from matching the old unit, which was frequently oversized when it was installed. Oversized cooling short-cycles and leaves a house cold and clammy rather than cool and dry.

Cold-climate models do, holding useful output well below freezing, and most installations here keep a backup for the coldest stretches. What decides it is your current fuel cost against your electricity rate, and which New Jersey incentives you qualify for — the state Whole Home program and your electric utility stack, and the amounts change from year to year.

Ask for three things and check them: current liability insurance, the appropriate license for your municipality, and EPA Section 608 certification for anyone handling refrigerant. Ask to see the documents rather than taking the logo on the van as proof. For gas work in particular, licensing exists because the failure modes are carbon monoxide and fire.

A hot water system that loses pressure has a leak — usually the relief valve, the expansion tank, or a fitting in the distribution piping. An expansion tank that has lost its air charge shows up as pressure climbing sharply when the system heats and then dumping through the relief valve, which looks like a faulty valve and is not.

On steam, water hammer — condensate trapped where steam wants to travel, almost always because a radiator or pipe run has lost its pitch. Shimming the radiator so it drains back toward the pipe fixes a surprising number of cases. Persistent banging after that usually means a sagging main in the basement.