Independent contractors, licensed in NJ

Covering 1 ZIP code

PTAC Repair and Replacement in Irvington, NJ

The self-contained unit under the window in most mid- and high-rise buildings along the Gold Coast and through Newark and Jersey City. The critical detail is the sleeve, because it is built into the wall and the replacement has to fit it.

  • Covering 1 Irvington ZIP code
  • Free to use, no obligation
Carbon monoxide alarm, a smell of gas, or soot around the furnace?

Leave the building and call from outside — that is an emergency services call, not a service call. A yellow burner flame or headaches that clear when you leave the house point the same way. For no heat in freezing weather, call rather than read on: the risk there is frozen pipes rather than comfort, and it arrives within hours.

Call about PTAC in Irvington

(949) 703-2282

Free to use, and there is nothing to pay us. You are never committed to going ahead.

What happens when you call

  1. You describe the problem and where you are.
  2. We put you in touch with a licensed contractor covering that area.
  3. They arrange the visit and agree the price with you directly.

Worth having to hand

  • Roughly how old the system is
  • What it is doing — or not doing
  • Your ZIP code
PTAC Repair and Replacement in Irvington, New Jersey

What to ask for on PTAC Repair and Replacement in Irvington

  • Measure the existing sleeve before choosing a unit
  • Chassis dimensions vary between manufacturers
  • Most buildings have rules about permitted models
  • Repair is often uneconomic past a certain age
Call about PTAC
  • Licensed & insured We match you with contractors who hold current licensing and cover.
  • Know what to ask Every page says what decides the price, so you can judge a quote.
  • Free to use We never charge you. Compare quotes and walk away at any point.
  • Same-day reply Inquiries answered the day they arrive, usually within a couple of hours.

How it works

Three steps, no obligation at any of them.

  1. 1

    Call and tell us what is wrong

    Describe the problem and give us your ZIP code. We match you with a licensed HVAC contractor covering your area — there is nothing to fill in and nothing to pay us.

  2. 2

    A local contractor gets in touch

    A licensed HVAC professional contacts you to discuss the problem and arrange a visit in Irvington. What they charge to attend or diagnose is theirs to set, so agree it with them up front.

  3. 3

    You decide

    Book the work, wait a season, or get a second quote. There is no obligation to go ahead with the contractor we introduce you to, and nothing to pay us either way.

What these repairs look like

Illustrative examples of the work described here. More in our disclaimer.

Before: condenser replaced and set on a level pad in Irvington, NJ After: condenser replaced and set on a level pad in Irvington, NJ
Condenser replaced and set on a level pad Sized from a load calculation rather than matched to the old unit, with the clearances the manufacturer specifies.
Before: ductless head fitted in a house with no ducts in Irvington, NJ After: ductless head fitted in a house with no ducts in Irvington, NJ
Ductless head fitted in a house with no ducts Line set run in a finished channel rather than taped to the siding, and sealed where it passes through the wall.
Before: attic ductwork sealed and insulated in Irvington, NJ After: attic ductwork sealed and insulated in Irvington, NJ
Attic ductwork sealed and insulated Joints sealed with mastic rather than tape, which fails within a few years and takes the saving with it.

PTAC Repair and Replacement in Irvington

Two things shape HVAC work in Irvington: the age of the building stock, and a climate that swings far enough to make both halves of the system work hard. Equipment is rarely the constraint here — fitting it to a house that was not designed for it is.

About 31% of homes in Irvington were built before 1940 — old enough to have been built with radiators and no ductwork at all; 76% of them heat with natural gas, so furnace and boiler work is the bulk of what comes up here. (US Census ACS 2022)

Repair or replace

The arithmetic differs from central equipment because a whole new chassis is not expensive by HVAC standards.

Repair under about seven years

Capacitors, fan motors, thermostats and control boards are all worth doing on a unit with life left.

Replace past ten, or on a sealed-system fault

A compressor or refrigerant circuit failure on an older PTAC usually costs more than a new chassis. Since the sleeve stays, replacement is a genuinely quick job.

Buildings do this in batches

If you manage a building where units are of an age, replacing in a planned batch is cheaper per unit than replacing them one emergency at a time — and it lets you standardize on one model and hold spares.

What a PTAC is and why the sleeve matters

A packaged terminal air conditioner puts the entire refrigeration circuit in one cabinet that slides into a sleeve through the exterior wall — no ductwork, no outdoor unit, each room independent. That independence is why they dominate apartment buildings and hotels.

The sleeve is a permanent part of the building. When a unit fails, the chassis is replaced and the sleeve stays.

Sizes are not universal

The common size is 42 by 16 inches, and a great deal of stock fits it — but older buildings and some manufacturers used different dimensions, and a chassis that is an inch out will not seal. Measure the sleeve before ordering anything.

Heat pump or electric resistance

PTACs come as cooling-with-electric-heat or as heat pumps with electric backup. The heat pump version costs more and is substantially cheaper to run through a New Jersey shoulder season. If you are replacing anyway, it is usually the better buy.

The building probably has rules

Condo and co-op boards commonly specify permitted models, exterior grille appearance and who may do the work, because the units are visible from the street and tied into building electrical. Check before ordering rather than after.

The full guide: everything about ptac repair and replacement — how the job works, what decides the price, and the questions worth asking before you book — is on the service page. This page covers what is different about it in Irvington.

Areas we cover in Irvington

Our Irvington coverage takes in the neighborhoods around Clinton Cemetery, Irvington East, Irvington Park and Myrtle Avenue / Western Parkway.

PTAC Repair and Replacement in Irvington — FAQs

What HVAC problem is most common around Irvington?

Steam systems heating some rooms and not others, which is almost always venting rather than a failing boiler. That pattern is regional rather than universal — the dense pre-war core — Newark, Jersey City, Hoboken, Bayonne and the Oranges. It is worth knowing before you book, because it tells you what someone should be looking hardest at here.

How much does HVAC repair cost in Irvington?

It depends on which part has failed, and the spread is wide. Capacitors, contactors, igniters, thermostats and blocked condensate drains are the inexpensive end and are usually done in one visit. Blower motors, control boards, gas valves and refrigerant leak repairs are the expensive end, and on an older system are worth weighing against replacement. Hudson, Essex and Union labor rates are a little above the state average. Call and describe the symptom and we will put you in touch with someone who can price it properly against your equipment.

Do you cover all of Irvington?

Yes, we cover Irvington and the surrounding area. Give us your ZIP code on the call and we will confirm before arranging anything.

How quickly can someone get to me in Irvington?

Call and we will put you in touch the same day, usually within a couple of hours during working hours. Outside the peaks an assessment is normally within a few days. During the first heat wave of the summer or the first hard freeze of the winter it stretches, which is the argument for booking servicing before the season rather than during it.

My AC is running but the house is not getting cool. What is wrong?

Usually one of four things: a blocked filter, an outdoor coil packed with debris, a failed capacitor, or low refrigerant from a leak. The first two you can check yourself in five minutes and they account for a real share of Irvington calls. If both are clear, it needs gauges and a meter — and if the charge is low, the leak needs finding rather than topping up.

Should I repair or replace my system?

The usual test is whether the repair costs more than about a third of a replacement on a system past two-thirds of its expected life, which is 15 to 20 years for most equipment. A compressor or heat exchanger failure on an older system generally means replacement; anything electrical on a newer one generally means repair. Ask for both numbers — a contractor who will only quote one is answering a different question.

Why is water coming from my PTAC?

Condensate that is not draining — a blocked drain path, or a sleeve that has lost its outward pitch. Both are common and both are usually a straightforward fix.

Are PTAC units expensive to run?

The electric-resistance heat versions are, because resistance heating is expensive everywhere. The heat pump versions are considerably cheaper through a New Jersey shoulder season and are worth the difference at replacement.

Call now How it works